Insights into the IEA Global Hydrogen Review

The use of hydrogen and ammonia in the power sector is gaining traction, with several projects already announced. In the short term, emissions from existing power plants can be reduced by co-firing ammonia, while the long-term goal is to rely solely on ammonia or hydrogen. Furthermore, global hydrogen demand is expected to reach almost 100 Mtpa by 2024, with demand for low-emission hydrogen projected to grow by about 10% in 2023. To meet the 2030 targets of the Net Zero Emissions (NZE) scenario, approximately two-thirds to three-quarters of low-emission hydrogen must be produced via electrolysis, highlighting the rising importance of this technology. Within this article, the Fuel Cell Compass is reviewing the IEA Global Hydrogen Review 2024 and drawing conclusions from it.

The prognosed hydrogen production capacities do not match the upcoming demand

Despite a 10% increase in low-emission hydrogen production over the past year, current output remains below 1 Mtpa, compared to an actual demand of around 100 Mtpa. Government intervention could boost the demand to 6 Mtpa by 2030, but this would still represent only about 10% of the Net Zero Emissions (NZE) goal for 2050. With the current ambitions, this goal will not be achieved.

Furthermore, the installed capacity for electrolyzers in 2023 is just one-sixth of the amount projected in the Global Hydrogen Review 2021, indicating slower progress than expected. Even if all proposed projects were completed, electrolyzer capacity would reach only 0.7 GW by this year—falling well short of the EU Hydrogen Strategy’s 2020 interim target of 6 GW.

A key challenge is the lack of clarity around fully developing announced projects: a mere 4% of all projects through 2030 have either begun construction or reached a final investment decision (FID). The Compound Annual Growth Rate (CAGR) for water electrolyzer installations was about 60% from 2020 to 2023 and could reach 400% if all projects have met their 2024 deadlines. However, achieving the NZE goal demands more than doubling that CAGR annually—surpassing the growth rate of solar photovoltaics documented over the last two decades.

China is significantly raising its share of global electrolyzer capacity

China is expected to account for three-quarters of the new electrolyzer capacity additions, raising its share of global capacity from 55% to 70%. Even if all projects in the United States and Europe become operational, Europe would still hold only about 15% of global capacity, leaving China firmly in the lead. This is further underscored by China’s 40% share of global FIDs.

Economic, organizational and technical challenges remain

From a cost, transportation, and storage perspective, low-emission hydrogen is significantly more expensive than its grey alternative. Although 40,000 km of pipelines have been announced—aligning closely with NZE targets—only 2% have reached FID. Hydrogen storage targets also lag behind; the current plan provides for 10 TWh of storage, far less than the 230 TWh needed by 2035.

Project developers face multiple hurdles. Unclear regulations complicate planning, and fossil-based hydrogen remains cheaper, creating uncertainty in demand. Delays in government funding, as well as licensing and permitting challenges for water supplies or grid connections, further slow progress. Administrative shortfalls and difficulties scaling up round out the primary obstacles for this emerging sector.

Need for Action: Boosting Demand & Enabling Policy

With this in mind, significant improvements in electrolysis are needed to reach the NZE scenario. Currently, the cost of producing renewable hydrogen is around one-and-a-half to six times higher than fossil-based hydrogen. Although consumers might see a price difference, the primary burden falls on industry. Governments must therefore create the right incentives to make low-emission hydrogen more attractive.

This point is reinforced by the rapid yet underutilized growth in electrolyzer manufacturing capacity, with plants operating at just 10% of their full potential in 2023—yet again illustrating that demand lags behind production. Last year, nearly USD 100 billion in public funding was announced, but the allocation is imbalanced: one-and-a-half times more support goes to supply, while data shows demand is in greater need.

Many electrolyzer manufacturers operate domestically, but their expansion into global markets presents a considerable opportunity. The European Hydrogen Bank auction underscores this trend, showing that up to 25% of projects would consider Chinese electrolyzers, while 50% intend to purchase from European Union manufacturers—a clear indication of export potential. In 2023, proton exchange membrane (PEM) technology constituted 22% of installed electrolyzer capacity, whereas alkaline systems surpassed 60%. While PEM electrolyzers are more prevalent in Europe, projects in the United States and China are also on the rise. Meanwhile, the Global Hydrogen Review indicates that the share of alkaline electrolyzers could shrink from 70% today to 55% in 2030, suggesting they may not be the ideal choice and leaving room for further exploration of other technologies like PEM.

Despite heightened interest in green hydrogen, current progress is insufficient to meet NZE goals. Slow electrolyzer deployment, inadequate demand-side investment, and regulatory hurdles are stalling the necessary surge. Although export prospects remain a bright spot, decisive policy measures and a marked acceleration in deployment rates are crucial to replace fossil fuels and secure a sustainable energy future. The possibilities are within reach—they just have to be seized.

Source

IEA Global Hydrogen Review

Newsletter

Hier informieren wir regelmäßig über alle wichtigen Entwicklungen im Bereich des Wasserstoffs, der Brennstoffzelle und des Elektrolyseurs.

Downloads

Hier informieren wir regelmäßig über alle wichtigen Entwicklungen im Bereich des Wasserstoffs, der Brennstoffzelle und des Elektrolyseurs.

Whitepaper: In-line Viscosity Measurement

Download a white paper on innovative solutions in the areas of real-time process monitoring and quality assurance